Plug and Mix Loudbass

Are you eager to make your low end truly stand out? Working on a dancefloor project but lacking that crucial 'thump' to compete? Look no further! This amazing plug-in is here to beef up your low end and enhance your stereo field simultaneously. You can easily choose the bass frequency to boost or cut. Then, adjust the stereo width, either expanding it for a wider sound or narrowing it to a pure mono signal. Features: 1. Freq Hz: Adjust the operating low-frequency bandwidth. 2. Boost dB: Control the extra boost for low frequencies, with the center frequency depending on the FREQ value. 3. Width: Control the stereo width of low frequencies, expanding or narrowing the bass image. System Requirements: OS X 10.9 or above, Windows 7 and above, minimum 2 GB RAM, support for 32 & 64-bit, and authorization for up to 5 computers.

Using this Loudbass plug - in is a breeze. First, open your audio project where you need to enhance the low end. Install the plug - in according to the system requirements (make sure your OS is OS X 10.9 or above or Windows 7 and above, with at least 2 GB of RAM). Once installed, you can start using it. To adjust the bass frequency, find the 'Freq Hz' control and set it to the desired low - frequency bandwidth. If you want to add more punch to the low frequencies, use the 'Boost dB' control. Remember, the center frequency of the boost depends on the 'Freq Hz' value you set. For adjusting the stereo width of the bass, use the 'Width' control. You can expand it for a wider sound or narrow it down to a pure mono signal. As for maintenance, keep your operating system and the plug - in updated to ensure smooth performance. Also, since it's authorized for up to 5 computers, make sure you don't exceed this limit to avoid any licensing issues.